assetsbta.blogg.se - 3par ssmc change vmware ip

The exact steps you need to take will depend on the version of the Service Processor you are running. Integrating the 3PAR Service Processor with vCentre You will see a full set of instructions on how to do this, with the choice of doing this via CLI, SSMC and IMC. You will then be presented with a System Group Registration Token to copy and paste onto each 3PAR to perform registration.This allows you to group all your organisations devices You will then choose a system group you want to assign the device to.Click on the HPE 3PAR StoreServ / StoreOnce Register Systems link on the Welcome Page (Settings > Register Systems).Logon to InfoSight with your HPE passport ID.We will run through these steps in the next sections: Registering system with InfoSight

Ensure that the RDA transport mode is used for the Service Processor.Configure VMware integration in the Service Processor.If the above requirements are in place you will then be able to complete the following high level steps to get InfoSight with cross-stack analytics. VMware vCenter versions 5.5, 6.0 or 6.5.

3PAR Service Processor must be configured to use the RDA Transport Agent (SSA is not supported).

3PAR OS 3.3.1 with Service Processor 5.0 MU3 or later.

Minimum 3PAR OS 3.2.2 MU4 minimum with Service Processor version 4.4 MU7 or later.

Additionally if you wish use Cross-stack Analytics for VMware the following requirements apply:.

An active support contract is in place, which you can verify with the HPE Warranty Checker.

3PAR Call Home enabled, as I describe here.

Before you register your system in InfoSight you need the following prerequisites in place: Hello 3PAR Guys, today I will show you how to enable VMware integration in HPE InfoSight. This allows a number of insights into the performance of VM’s held on the storage. This guest post by Armin Kerl runs through the process of setting up 3PAR Cross-stack Analytics for VMware. HPE previously announced the availability of HPE InfoSight for 3PAR.